Wireless Lapel

1.) Ensure the sound board is on. See “Turn Sound On/Off (Quick Reference)”.

2.) Locate the wireless lapel, found to the left of the soundboard.

3.) Open the battery door by holding down two buttons/latches on the sides and pulling towards yourself.

4.) Insert batteries. The batteries are located in between the soundboard and the sound computer monitor. The lapel mic requires two batteries.

5.) Locate the lapel microphone piece and select the preferred microphone piece. Attach it to the top of the wireless lapel. Ensure that the microphone is fully inserted, the inserted section should be flush. Note: The insert is keyed, make sure to insert it properly.

6.) Close the battery door and locate the power button on top, shown in the picture. Press and hold until the light turns on. If it doesn't, recheck the batteries.

7.) Mic on should look like the picture below.

8.) On the soundboard, locate the wireless handheld channel, channel 14. Adjust to desired volume. Ensure the “mute” button is not lit.